裝載機工作時間長了之后，轉向系統難免出現一些偏差，此時應該將山東裝載機放在平整路面上，快速原地空載轉向。如果左右轉向的時間差超過0.3S，則證明山東裝載機的轉向系統出現問題，需要按以下步驟進行調整。

1、將裝載機流量放大閥端蓋拆下，增加調整墊片可使右轉向時間減少及左轉向時間增加，減少調整墊片其結果相反；

The Shandong loader flow amplifier valve cover removed, the increase in the adjustment of the gasket can make the right to reduce the time and left to increase the time, and reduce the adjustment of the gasket; 

2、增加或減少裝載機兩個0.25mm的調整墊片可使轉向時間變化0.1S，調整后將端蓋裝好。
Increase or decrease the Shandong shim two 0.25mm loader can make to the time variation of 0.1S, will be adjusted to cover up.